![]() ![]() If more automated and tight configuration of these wireless parameters is required, the OpenWRT softrouting system can be used instead of the Ubuntu system. The modes supported by hw_mode include a, g, channel channels are related to hw_mode, country_code, etc. Wpa_passphrase: Wireless AP password, here is set to 12345678įor more information, the configuration of nf is undoubtedly very complicated. Ssid: wireless AP name, here set Example-Wifi-Name Interface: enable the wireless network card of the wireless AP hotspotīridge: bind to the br0 bridge, so that the wireless AP hotspot and the Ethernet port are in the same LAN Introduction to Yocto Project Release layerĬhannel = 11 macaddr_acl = 0 auth_algs = 1 ignore_broadcast_ssid = 0 wpa = 2 wpa_passphrase = 12345678 wpa_key_mgmt =WPA-PSKĬountry_code: country code, China uses CN Use root to log in to the system interface ![]() Configure IP address and routing using ip and netplan Install the necessary software packages for managing AP hotspots There are requirements for the IP LAN segment of the wireless hotspot ![]() There is no requirement for the IP LAN segment of the wireless hotspot Ethernet port general parameter configuration ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |